DOI: 10.56195/20793332-2026-26-1-26-30
S. A. Shemyakin1, A. Yu. Cheban2, E. A. Shishkin1, V. Yu. Voronin3
- Graduate School of advanced engineering, Pacific National University, Khabarovsk, Russian Federation
- Institute of Mining, Khabarovsk Federal Research Center of the Far Eastern Branch of the Russian Academy of Sciences, Khabarovsk, Russian Federation
- Areal company, Khabarovsk, Russian Federation
- Abstract:
- It is known that short-delay detonation should help reduce the cost of explosives, reduce the seismic impact on objects, minimize destruction deep into the massif, as well as the formation of rock mass collapse. The purpose of the article is to develop a methodology for determining the explosion energy based on integrating the dynamic tensile strength of the rock over the depth of the well. To achieve this goal, a calculation scheme has been developed for determining the energy consumption for destruction without deceleration and pre-destruction, as well as with pre-destruction and deceleration for a rectangular grid consisting of four wells. The causes of incomplete crushing of the rock during a rectangular grid and a massive explosion are revealed, and the main provisions for eliminating this disadvantage due to pre-destruction during deceleration are indicated. The size of the savings of explosives due to pre-destruction during short-range detonation has been determined. The developed technique allows a more reasonable approach to the purpose of the specific consumption of explosives. The methodology takes into account the effect of the fracture area of a piece of rock on the energy consumption of blasting operations. The technique has been positively tested at the Kekura gold deposit in the Chukotka Autonomous Region.
- Keywords:
- explosion, borehole, grid, voltage, rupture, energy consumption
- For citation:
- Shemyakin S.A., Cheban A.Yu., Shishkin E.A., Voronin V.Yu. The energy principle of analyzing and controlling the parameters of short-range blasting in quarries. Mine Surveying and Subsurface Use. 2026;26(1):26-30. (In Russ.). https:// doi.org/10.56195/20793332-2026-26-1-26-30.
- Information about the authors:
-
- Stanislav A. Shemyakin – Dr. Sci. (Eng.), Professor of the Graduate School of advanced engineering, Pacific National University, Khabarovsk, Russian Federation
- Anton Y. Cheban – Cand. Sci. (Eng.), Senior Researcher, Institute of Mining, Khabarovsk Federal Research Center of the Far Eastern Branch of the Russian Academy of Sciences, Khabarovsk, Russian Federation
- Evgeny A. Shishkin – Cand. Sci. (Eng.), Associate Professor of the Graduate School of advanced engineering, Pacific National University, Khabarovsk, Russian Federation; e-mail:
This email address is being protected from spambots. You need JavaScript enabled to view it. - Vyacheslav Y. Voronin – Chief Engineer, Areal company, Khabarovsk, Russian Federation
- References:
-
- 1. Тюпин В.Н. Интервалы замедления для качественного дробления трещиноватых массивов взрывом в карьерах. Горный информационно- аналитический бюллетень (научно-технический журнал). 2023; 12: 70-78. https://doi.org/10.25018/0236_1493_2023_12_0_70. Tyupin V.N. Deceleration intervals for high-quality crushing of fractured massifs by explosion in quarries. Mining Information and Analytical Bulletin (scientific and technical journal). 2023; 12: 70-78. (In Russ.). https://doi.org/10.25018/0236_1493_2023_12_0_70.
- 2. Тюпин В.Н. Обоснование предельного интервала замедления для снижения сейсмического действия массовых взрывов на карьерах. Горный информационно-аналитический бюллетень (научно-технический журнал). 2022; 12: 67-76. https://doi.org/10.25018/0236_1493_2022_12_0_67. Tyupin V. N. Justification of the maximum deceleration interval to reduce the seismic effect of mass explosions in quarries. Mining Information and Analytical Bulletin (scientific and technical journal). 2022; 12: 67-76. (In Russ.). https://doi.org/10.25018/0236_1493_2022_12_0_67.
- 3. Huang J., Zhang G., Luo Y., et al. Study on timing sequence control fracture blasting excavation of deep rock masses with filled joints. Scientific Reports. 2021; 11: 21056. https://doi.org/10.1038/s41598-021-00438-9.
- 4. Vennes I., Mitri H., Chinnasane D.R., et al. Effect of stress anisotropy on the efficiency of large-scale destress blasting. Rock Mechanics and Rock Engineering. 2021; 54: 31-46. https://doi.org/10.1007/s00603-020-02252-7.
- 5. Huang Z., Ren F., Yuan L., et al. Tensile strength and damage characteristics of rock under different test methods. Experimental Technology and Management. 2020; 37(10): 45-49.
- 6. Tang H.-L., Liu X., Yang J., et al. Experimental study on the influence of delay time on rock fragmentation in bench blasting. Applied Sciences. 2022; 13: 85. https://doi.org/10.3390/app13010085.
- 7. Zhao Y.-B., Su D.-D., Fan Y., et al. Simulation of rock fracture process and fragmentation analysis with different short delays for group hole blasting. Blasting. 2023; 40 (3): 92-100. https://doi.org/10.3963/j.issn.1001-487X.2023.03.013.
- 8. Митюшкин Ю.А., Лысак Ю.А., Плотников А.Ю. и др. Оптимизация параметров взрывных работ увеличением интервалов замедления. Горный информационно-аналитический бюллетень (научно-технический журнал). 2015; 4: 341-348. Mityushkin Y.A., Lysak Y.A., Plotnikov A.Y., et al Optimization of blasting parameters by increasing the delay intervals. Mining Information and Analytical Bulletin (scientific and technical journal). 2015; 4: 341-348. (In Russ.).
- 9. Мартьянов В.Л., Колесников В.Ф., Лапаев М.Н. Исследование параметров буровзрывных работ при комбинированной технологии разработки наклонных месторождений. Техника и технология горного дела. 2022; 3 (18): 53-78. https://doi.org/10.26730/2618-7434-2022-3-53-78. Martianov V.L., Kolesnikov V.F., Lapaev M.N. Investigation of the parameters of drilling and blasting operations using a combined technology for the development of inclined deposits. Journal of Mining and Geotechnical Engineering. 2022; 3(18): 53-78. (In Russ.). https://doi. org/10.26730/2618-7434-2022-3-53-78.
- 10. Шевкун Е.Б., Лещинский А.В., Добровольский А.И., и др. Разработка сближенных наклонных пластов каменного угля в разнопрочных и мерзлых вмещающих породах: монография. Москва, 2019: 256. Shevkun E.B., Leshchinsky A.V., Dobrovolsky A.I., et al. Development of converged inclined coal seams in variously durable and frozen host rocks: monograph. Moscow, 2019: 256. (In Russ.).
- 11. Лещинский А.В., Шевкун Е.Б. Разрушение скальных пород при открытых горных работах: монография. Хабаровск, 2020: 188. Leshchinsky A.V., Shevkun E.B. Destruction of rock formations during open-pit mining operations: monograph. Khabarovsk, 2020: 188. (In Russ.).
- 12. Катанов И.Б., Скачилов П.Г. О совершенствовании технологии и повышении безопасности взрывных работ при увеличении вместимости ковша экскаватора. Вестник Кузбасского государственного технического университета. 2014; 2 (102): 161-164. Katanov I.B., Skachilov P.G. On upgrading of technology and blasting safety by increasing the capacity of the bucket excavator. Bulletin of the Kuzbass State Technical University. 2014; 2(102): 161-164. (In Russ.).
- 13. Штукарин Н.Г. Физика взрыва в прикладных задачах. Красноярск, 2010: 309. Shtukarin N.G. Physics of explosion in applied problems. Krasnoyarsk, 2010: 309. (In Russ.).
- 14. Шемякин Е.И., Кочанов А.Н., Деньгина Н.И. Параметры волн напряжений и предразрушение прочных пород при взрыве. Разрушение взрывом и необратимые деформации горных пород: Сб. науч. тр. Москва, 1997: 10-17. Shemyakin E.I., Kochanov A.N., Dengina N.I. Stress wave parameters and pre-fracture of solid rocks during explosion. Explosion destruction and irreversible deformations of rocks. Moscow, 1997: 10-17. (In Russ.).
- 15. Угольников В.К., Симонов П.С., Определение переводных коэффициентов при расчете эквивалентных зарядов дробления. Вестник Магнитогорского государственного технического университета им. Г. И. Носова. 2007; 4 (20): 14-17. Ugolnikov, V.K., Simonov, P.S., Determination of conversion coefficients in the calculation of equivalent crushing charges. Bulletin of Nosov Magnitogorsk State Technical University. 2007; 4(20): 14-17. (In Russ.).
